How To Do Crown Molding

Scarf joints are used to connect two pieces of crown moulding when the wall is longer than a single piece of the trim. And that means no tricky compound angles to cut Garrett will explain that more in the video.

How To Hang Crown Molding How Tos Diy

Use a stud finder to locate the studs.

How to do crown molding. Measure the wall from corner to corner. Crown molding provides a dramatic finishing touch to interior spaces but the installation process can be intimidating to anyone who has not attempted it. The large often complex molding profiles available in crown molding there are many and compound-angle miters where pieces join are difficult to accurately measure cut and install.

Using a coping saw Image 2 is the easiest way to cut the corners because a coped joint is tighter than a mitered joint. Measure and mark the molding with the length of the front piece of baseboard starting from the deepest part of the 45-degree cut. How to Install Crown Molding.

Swing the blade of the miter saw 45 degrees to the left. This will help you keep the moulding straight. Youll also want to nail the crown moulding into a stud for a secure hang.

Holding the crown down below the ceiling a bit around 12 allows you to keep the crown molding level around the entire room. The new piece of crown mold has an angle as well. Cut at one mark then move the molding along to the next mark.

Sort of yin and yang. He nailed the old crown mold pieces to the ceiling upside down so the angle that is naturally found on crown molding was at the front. Take a piece of crown molding longer than the front of the cabinet and cut a 45-degree angle off one side.

Make sure that the side of the molding that youve finished is facing up. Draw a faint line where the bottom of the crown moulding will lay. Cut the Molding Swivel the saw to a 45-degree angle to match the direction of the molding set the board against the saw at the mark and make the cut.

Set the miter saw to a 45-degree angle cut. Make faint pencil marks high on the wall to guide you as you nail. Write your measurement down to use when cutting your crown moulding.

Standard crown molding can be cut at 38 degrees on one flat and 53 degrees on the other. Another way is to cut 45-degree angles on both edges with the table saw. Cut the Corners of the Molding The hardest part of installing crown molding is cutting the corners.

Two pieces are cut at opposing 45-degree angles and overlap to create a splice. This Old House general contractor Tom Silva shares some tricks of the trade for cutting crown molding for miters scarf joints and copes. See below for a s.

Place the first piece of moulding upside down on the saw with the scrap end to the right. When turned upside down like that the two fit directly together. Measure and mark the front section of crown molding to the cabinet width.

Router bits are available in sets to cut all three angles and put a nice bevel on your crown molding at the same time. You cant do it like any other trim pieces because the molding sits at an angle between the wall and the ceiling Image 1. Then slide the molding to the right side of the blade to cut a piece at right hand for an outside corner of the crown.

Using level flat crown also means that the gap between the crown and ceiling will change if your ceilings are uneven. Cut Crown Molding for Front of Cabinet Measure the length of the front piece of baseboard. You can hold the molding using clamps or simply with your hands and then start cutting.

Place the crown molding so that it is rests upside-down and at a 45-degree angle against the saw fence.

Installing Crown Molding To Be Super Chunky And Beefy